ZXT-600 automatically start the air conditioner when there is no user ?

[Vinteli_Tai 0]

I have a case of turning off the air conditioner on the FIBARO software with the ZXT-600 to hang out. When I came back, the air conditioner was still working when no one was there. other times when weekly outings and similar situation above waste energy and cost money. But after checking again, the air conditioner is still operating normally. Does anyone have a solution to guide me to completely handle the above situation?

[Martin_N 146]

@Vinteli_Tai

 

Hello,

// But after checking again, the air conditioner is still operating normally.//
I assume this means that you have checked the control in all modes, on, off, manual, cooling, heating, dehumidification,... and everything is working correctly via the Fibaro control?

Check the original controller, if it is not hanging around somewhere and cannot issue commands (for example, through the scheduler). Alternatively, take the batteries out of it.

Then I would check the conditions for your scenes, or the control method from Fibaro. In the log, check whether the commands (turning off) were executed, whether another command (turning on) was executed after you left.

It can also happen that there could have been a short-term power outage and some devices can start in a certain mode after turning on the power. Check if this behavior is turned off.

eM.