Heatit Z-Relay

[LBH 5]

Hello,

 

did someone found the way how to get in Fibaro HC2 power metering reports and leak sensor status reports from Heatit Z-Realy? If yes, please share the solution.

 

Thank you

 

[RobertL 20]

Have you tried to contact Heatit about this ?

 

Please login or register to see this link.

[LBH 5]

Sure, it was one of the steps I already taken.

 

I followed their advice, unfortunately it didn't change anything. Here is what they suggested:

 

Quote

Lets say the device is factory reset and just included in Fibaro. 

The configuration that is needed to be is the following;

Set associations from 

Endpoint 0 to Gateway in Multichannel modus. 

(you may need to set this twice beacuse of a small bug in fibaro.)

 

For temperature to be reported I had to set multichannel association in Endpoint 2 and 3  in Group 2 to HC2 on top of it to work, but as I wrote earlier, I can't find any way so far how to get power and leak sensor reports to HC2. 

 

Hopefully somebody is using this device with Fibaro and knows some workaround how to make it work