Neo Coolcam motion sensor still breached/coolcam stale wzbudzony

[auxx 0]

Hello,

 

Is anybody know the parameter need to be changed in order to sensor to be back in a safe mode because it is still breached after movement?

Nie umiem zdefiniować parametru który odpowiada za zwolnienie sensora z trybu breached. 

 

Regards

Jakob

[Leszek_Fibaro 6]

I have the same problem. My sensor has a factory set On / Off Duration time of 30 seconds. This is the "2" parameter. This can be changed in Configuration. But entering a new on / off time = 12 seconds does not work. The sensor still has an active time of "Breached" 30 sec. This is shown by the sensor status icon: czujnik_ruchu100.png

Please login or register to see this attachment.

Please login or register to see this attachment.

Please login or register to see this attachment.