Secure SRT321 sending ON command to many devices

[Ole 14]

Hi! I have a 8 Secure SRT321 and so far 5 of them have sent binary switch set (on and sometimes off) to a heap of device ID's. (I don't have devices for all of these ID numbers either.) And I only have two device ID's in group 2 which are Fibaro wall plugs. Gateway is in group 3 and 4 (report groups). Anyone know what is going on? Since so many of them are doing this I haven't considered them being broken very likely. See attached images from Z-wave Zniffer and manual for thermostat associations. ID 157, 160 and 161 are three of my SRT321. Thanks for any input.

 

 

Please login or register to see this attachment.

Please login or register to see this attachment.

Please login or register to see this attachment.

[m.roszak 481]

Looks like an issue with the SRT.
Remove all nodes from given association groups and add those wallplugs again - this may help with this - it will clear the group completely and add again only 2 devices.

[Ole 14]

37 minutes ago, m.roszak said:

Looks like an issue with the SRT.
Remove all nodes from given association groups and add those wallplugs again - this may help with this - it will clear the group completely and add again only 2 devices.

Hi! I excluded (and reset the SRT321) yesterday and then included it again, but this still happened this morning, but I'll give it a try in case something wrong happens when adding them to the gateway.