Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'zw095'.
Dear friends, have a problem with adding Home Energy Meter Gen5 (ZW095) from Aeotec to my HC2 (v4.150). The device was added but left unconfigured. It doesn't read value of currents and a voltage values shown on the screen but there is no change in time (see attached screen shoots). On the Aeotec web site I found out information that there is no information about compatibility of ZW095 with HC2 (https://aeotec.com/z-wave-gateways). But on the forum I've seen some topics about setting up of ZW095 in the HC2 interface. That's why I can't understand if it my personal issue with adding ZW095 or it's a real incompatibility.
Hello I have HC2 with the latest 4.532 beta The Home Energy Meter seems to be on the latest firmware. Only Total of Power in Watt an the the Total of Energy in kWH are updatet. All of the other readings aren't updatet in HC2 I've tried to change the parameter 101 to 4144911 to have all the readings in HC2, but in my case, it allways stays at default, which is 2. Also any other parameter can't be changed. Below screen shots of the Aeotec Firmware, parameters, the Aeotec Parameter Calculation sheet, the Polling intervall If I set a polling interval, in my case 30 seconds, the readings in HC2 get updatet. Also the Aeotec ZW095 home Energy Meter doesn't show up in the actual Android Fibaro APP. Does anybody know, how to change the aeotec parametes? Thanks in advance Best Regards Fabir