Danfoss Living Connect in heating panel ?

[domotique-store 0]

Is the Danfoss living connect manageable with the heating pannel or only with scene ?

I've tried with heating pannel but my danfoss setpoint was not updated.

With scene : no problem ?

Is it a bug or an implementation choice

Regards,

Jérôme Massiaux

Customer Service of domotique-store.fr

[Guest shapa]

Yes, it works fine in the panel (however it is really confusing as heating panel not showing anything about danfoss) - my 3 storey house all managed by HC2 with danfoss valves for two months without any issues.

Recently added Hortsmann thermostats.

[Krikroff 199]

domotique-store, I use Danfoss living connect in my house and manage them with heating panel with no problems

Please login or register to see this image.

/emoticons/default_icon_wink.gif" alt=";-)" /> BUT Living connect update the setpoint only each WakeUp, check the Wake up interval configured in Device Advanced options.

Please login or register to see this image.

/emoticons/default_icon_idea.gif" alt=":idea:" />

[domotique-store 0]

Ok I will check

Thanks for your response

Please login or register to see this image.

/emoticons/default_icon_smile.gif" alt=":-)" />

[Krikroff 199]

deleted

[domotique-store 0]

OK it work fine

Please login or register to see this image.

/emoticons/default_ohmy.png" alt=":o" srcset="https://forum.fibaro.com/uploads/emoticons/[email protected] 2x" width="20" height="20" />)

[Herke 0]

Can I use the Danfoss Link HC using Home Center 2 instead of multiple Fibaro FGS221 modules? My underfloor heating consists of eight sections.

[Lauri 6]

Can I use the Danfoss Link HC using Home Center 2 instead of multiple Fibaro FGS221 modules? My underfloor heating consists of eight sections.

No, Danfoss measures temperature from the same room it is installed.

For underfloor heating use 2x1,5kw relays and you need only 4 to control 8 sections. If some sections are same or opened room (kitchen+living room maybe) then you can control these with one relay output.

[TANE 12]

Other option is to use a I/O device

Control it via Virtual devices using http call's

Something like this one

Please login or register to see this link.

ETH-RLY16 - 16Amp, 8 Channel Relay Module

Docu

Please login or register to see this link.

[Herke 0]

Thank you both for this information. I try the solutions!

[Lauri 6]

Other option is to use a I/O device

Control it via Virtual devices using http call's

Something like this one

Please login or register to see this link.

ETH-RLY16 - 16Amp, 8 Channel Relay Module

Docu

Please login or register to see this link.

Does it have two way communication? I would like to know if the heating is really on or off. This is a little bit too important thing to have only one way communication used.

[qmoreira 0]

On 13/5/2013 at 3:11 PM, TANE said:

Other option is to use a I/O device

Control it via Virtual devices using http call's

Something like this one

Please login or register to see this link.

ETH-RLY16 - 16Amp, 8 Channel Relay Module

Docu

Please login or register to see this link.

Hi..

 

i just got to see these post... did you by any mean got to the ETHRLY16??

if yes, did you make it to manage the board to open and close relays with HC2?

 

hope to get some answer