Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


  • 0

Universal sensor temperature


Question

Posted

I just added a Fibaro Universal sensor, connected correctly IN1 and IN2 with GND to relay outputs of each a rain sensor and a ground humidity sensor, and one temperature sensor.

The inputs are detected/shown correctly, but I cannot find anywhere to read out the temperature.

Settings are set to default values, except for 'normal state' of the inputs, they are set to normally open.

Firmware running is 3.553 Beta.

2 answers to this question

Recommended Posts

  • 0
Guest PJ
Posted

You sure you have correct connection of 1-wire bus?

And have you connected the temperature sensor before adding to HC2? Beacuse if not, then you have to remove it from HC2 and add again. No changes in parameters are needed to see temperature sensor, so it should be visible roght after inclusion.

  • 0
Posted

I have found the quality of connection is sensitive. Would suggest you try removing, remaking the connections and re-adding.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...