DSB09104-ZWEU AEON

[fxpa 0]

Hello

I've a DSB09104-ZWEU with 2 clamps

Data can be read on HC2 interface but not in energy consumption panel.

The Node was working since i've changed my HC2 for a new one.

I've the last firmware.

Is there a parameter to change to make if work properly?

FXP

[A.Socha 114]

fxpa, may be 2 reasons

only full configured device in energy panel (check in adv setting do you got that info if not press reset to factory settings)

if yes on prv then you must unchecked checkbox in adv settings show in energy panel

[fxpa 0]

tks for this reply

Node seems to be fully configured

Here are the config panel for the main node and the 1rst Clamp

I've try to check and uncheck the CB

Please login or register to see this attachment.

Please login or register to see this attachment.

[A.Socha 114]

fxpa, looks ok check again in energy panel

btw 10 is a bit small value are you sure you really need that low value? it will create you lags think about 60s or more

[fxpa 0]

I've Put 10 just for tests It was 0 before

[A.Socha 114]

fxpa, 0 is the best value (then he using from global pooling)

[fxpa 0]

It's now with 0

I've make what you did then i've make a NetWork configuration and now the node is marked as not configured.

Really Strange

Please login or register to see this attachment.

Please login or register to see this attachment.

[A.Socha 114]

yes that is strange