Control APC UPS from HC2

[Guest lochnesz]

Hi,

Any ideas about how to check status and control an APC UPS (Smart-UPS 3000 XLM) with management card AP9619? As I understand it, Fibaro hasn't implemented LUA SNMP? That leaves us with telnet and http(s) options. However, my LUA knowledge is very limited. Can anyone help me with LUA code to check status and control the UPS?

It would for example be nice to get a push or e-mail message when the UPS is on battery power with estimated remaining run time in the message. The run time report could repeat like every 10 minutes, and when the run time is less than 10 minutes the HC2 should shut down.

Any LUA guru with some UPS knowledge? :->

[murnko 0]

lochnesz,

So far there is such solution available,

Please login or register to see this link.

About using network card functions, it should be possible to obtain http access to it through virtual device (believing installation guide), but I cannot provide any details, as I don't have UPS with network card. Could you tell what kind of interface and data you get from it?

Regards

[Guest lochnesz]

From http you get this kind of output to parse. Attached a screenshot and the html code for it.

Any ideas?

Please login or register to see this link.

Please login or register to see this attachment.

[Maestrea 8]

Hi,

Any ideas about how to check status and control an APC UPS (Smart-UPS 3000 XLM) with management card AP9619? As I understand it, Fibaro hasn't implemented LUA SNMP? That leaves us with telnet and http(s) options. However, my LUA knowledge is very limited. Can anyone help me with LUA code to check status and control the UPS?

It would for example be nice to get a push or e-mail message when the UPS is on battery power with estimated remaining run time in the message. The run time report could repeat like every 10 minutes, and when the run time is less than 10 minutes the HC2 should shut down.

Any LUA guru with some UPS knowledge? :->

Hi, the solution:

Please login or register to see this link.

Thanks.