Manual Z-wave routing for better signal communication

[geeklabs 1]

Transfer Failed! Something that we all hate to see.

As we know that zwave creates a mesh network and in HC2 it is created automatically.

What I really want to know that if there is a possibility to manually hop the signal.

I have a few relays, roller shutters and dimmers in room 'A' that are unable to contact with HC2 directly. However, I have a set of relay and dimmer which is in room 'B' which is adjacent to room 'A' where the signal it transmitted successfully. I wonder why is it not hopping the signal. I have tried configuring the Z-wave network several times but still no luck.

Any solutions to this problem?

[Fibarium 0]

"Transfer Failed!"...same problem here...no matter what the distance is though...

[j.nowacki 5]

geeklabs, routing table cannot be updated manually. Routes are chosen basing on time of response using different routes. You can re-build Z-wave network to establish new communication routes with unreachable node.

[geeklabs 1]

geeklabs, routing table cannot be updated manually. Routes are chosen basing on time of response using different routes. You can re-build Z-wave network to establish new communication routes with unreachable node.

How do I rebuild Z-wave network? How is it different from re-configuring all devices?

[j.nowacki 5]

geeklabs, it depends on software you are using, in v4 there is proper option for that in configuration, on v3 you need to run a lua command to do that.

[dawiinci 5]

The command is this one:

Please login or register to see this code.

It really helps a lot!

[A.Socha 133]

dawiinci, Or if you got 4.030 you can do that by GUI

Configuration -> Z-Wave network -> mesh reconfiguration

[geeklabs 1]

dawiinci, Or if you got 4.030 you can do that by GUI

Configuration -> Z-Wave network -> mesh reconfiguration

I updated the firmware and performed "Mesh Reconfig" and non of the devices worked. I waited for about 18 hours and then finally restarted the HC2. After restart still the same old "Transfer Failed"

And then I clicked on Reconfigure all devices and now nothing works.