Full set of LEDS on the box - no response via UI

[budda 5]

My HC2 has decided to no longer load up the Web UI fully - it sat on the spinning animation.

I then rebooted the box and now it flashes all the blue LEDs one at a time and eventually sites with all the LEDs on.

I tried unplugging, then plugging in and holding the recovery button whilst powering on and it seems to make no difference.

Tried the recovery static IP address too -- just in case it had switched over when holding down the buttons too long. No response.

The box doesn't respond to pinging its DHCP or static IP addresses (from the manual).

What do all the LEDs being on mean ? Is there a way to recover?

[ Added: 2015-01-22, 23:12 ]

I've just booted the HC2 up whilst having a SVGA monitor plugged in to the socket on the box.

After loads of reboots with all the LEDs on, since plugging in the monitor i now don't get all the LEDs -- just the usual 3, when connected to the Internet.

It's now working with 4.032 firmware - i don't even remember pressing the upgrade button yet. I was on 4.019 this morning!

[djesko 1]

Hi

My box did the same but no luck on getting it to work , tried all the steps you said and 20 times more

Please login or register to see this image.

/emoticons/default_smile.png" alt=":)" srcset="https://forum.fibaro.com/uploads/emoticons/[email protected] 2x" width="20" height="20" />

Will return it to mu seller today !

But your box did get up and running again ?

Niklas

[budda 5]

Yeah all up and functioning now with same config as it had before the black out.

Very odd.

Whilst having the monitor connected I noticed errors about cron scheduler failing to start. Not sure if that's "by design".

Ah one other thing i Did do was unplug the Ethernet cable and boot up then reboot, then plug cable back in and reboot again.

[djesko 1]

I did not get any pic ,

[budda 5]

I did not get any pic ,

Vga or dvi connection?

[djesko 1]

VGA and there was one HDMI under the plate ,

[budda 5]

VGA and there was one HDMI under the plate ,

Hdmi. Sounds like you have a newer box.

[djesko 1]

newer but dead

Please login or register to see this image.

/emoticons/default_smile.png" alt=":)" srcset="https://forum.fibaro.com/uploads/emoticons/[email protected] 2x" width="20" height="20" />

[UrSv 6]

Where do you live djesko?

[djesko 1]

Trelleborg

[UrSv 6]

Bummer, that's a bit too far for me to help from Linköping.

[djesko 1]

Bummer, that's a bit too far for me to help from Linköping.

Thanks , the box is now at webhallen.

Just wait and install some controller SW on my raspberry with usb stick ! any good SW to recommend ?