Roller Shutter to control projector screen

[klbeprivat 0]

Hi,

 

I planned to control my projector screen by using the roller shutter module. Unfortunately the wiring looks different than expected...

My projector screen has a control box, which provides 3 buttons (up, down, stop) and a receiver for the RC. I thought it should be simple to connect the Roller Shutter module between the control box and the screen motor.

 

The cable from controler box to the screen has 4 wires:

- Black

- Brown

- Blue

- Yellow/Green (Ground)

 

Dependent on the situation I can document the following details:
 

               off                        down       up         off
              (upper position)                                 (lower position)

Black      power                   power       power    power    

Brown     n/a                        power       n/a         power 

Blue        power                   n/a            power    power

 

It looks like the motion is controlled by Brown and Blue, but why do I have additonally a Black wire which provides constant power? I also don't have a Neutral wire. I'm confused. 

Please help. How do I need to connect the Roller Shutter?  

 

Thanks,

 

Klaus

[Tundel 9]

Please take  a look  here. 

Please login or register to see this link.

Maybe, if cinema screen uses 24V, you should use  2x1.5KW Relay (FGS221) module instead of roller shutter module.

 

 

[cadalarm 0]

Hi

 

i same similar situation and need to activate separate device module through II command on the figaro roller shutter. If I press II command it sends z-wave command to the panel. How to use this signal for activating 1x3KW module?