MH-S314-EU / MCO Home not showing all devices

[1152 33]

I have bought a few MCO Home devices of the MH-S310-EU series and installed them to control both directly wired lamps and lamps controlled by association. In my bathroom and bedroom this works flawlessly for all devices directly connected or by association - and I can see/choose all the devices in the room, (even the door and smoke sensors). In the other bedroom it works as well, but not all devices are shown. I suspect this has little or nothing to do with the S314 device, but rather is a problem with Fibaro HC2/the setup of the network. As you can see from the attached files the master reports waiting for wake up. (The/some of the slaves report not configured, but that is the case for 1-3 of the slaves on my other S314s with out any other issues in my other rooms). Bu I´m at loss to the exact cause and nature of my problem and how to fix it. BTW the room/devices were installed/setup at Sunday   

Please login or register to see this attachment.

Please login or register to see this attachment.

Please login or register to see this attachment.

[frastr669 6]

I use them in my house also.. But my problem is that they just loose the Z-wave connection after a week or two.

so i have to exclude and include them again.. Thats frustrating since i have to do all the setup every time..

I just hope that Fibaro make a template for it

[PSL74 0]

On 02.12.2016 at 1:34 AM, frastr669 said:

I use them in my house also.. But my problem is that they just loose the Z-wave connection after a week or two.

so i have to exclude and include them again.. Thats frustrating since i have to do all the setup every time..

I just hope that Fibaro make a template for it

I have a same problem. How it is possible to ask Fibaro to make template for it? 

[frastr669 6]

I have tried to get them to do that for years. Same with the ID lock.