Motion sensor controlling switch

[harmdelaat 0]

I have a Fibaro motion sensor and a Fibaro Switch (FGS-223) that controls a light. I'm currently using association group 2 to use the motion sensor to switch on the light. I have two questions about this setup:

 

1. The motion sensor switches off the light too fast. Is it possible to extend the time, for let's say 1 or 2 minutes before it switches back off?
2. Sometimes I need the light to remain on (even after no movement for a longer period of time). Can I override this behavior (by using the switch) so that the light remains on, no matter if movement has been detected or not?

 

Thanks for helping!

[Jamie mccrostie 82]

12 hours ago, harmdelaat said:

I have a Fibaro motion sensor and a Fibaro Switch (FGS-223) that controls a light. I'm currently using association group 2 to use the motion sensor to switch on the light. I have two questions about this setup:

 

1. The motion sensor switches off the light too fast. Is it possible to extend the time, for let's say 1 or 2 minutes before it switches back off?
2. Sometimes I need the light to remain on (even after no movement for a longer period of time). Can I override this behavior (by using the switch) so that the light remains on, no matter if movement has been detected or not?

 

Thanks for helping!

@harmdelaatYou need to do some reading on building scenes for this.