Fibaro dimmer 2 value fault ?

[systemfel 21]

why is this not working on fibaro 2 dimmers  ???  i can not cheek  if the lights  are on ?   

 

I think this is a bug. Can anyone else test it. or tell how to check the value of a dimmer if it is on or off

if tonumber (fibaro: getValue (391, "value")) == 1 then fibaro: Call (391, "turnoff") fibaro: debug ( "turn off the light") end

 

Am I doing that wrong?

[sonnyboy 11]

It should be turnOff not turnoff. 

 

Works for me 

[DEBUG] 22:07:21: Test: 99

Please login or register to see this code.

 

Edited October 9, 2017 by sonnyboy

[petergebruers 1,265]

For dimmers in general, value means:

 

0 = off

1 = lowest level = 1 % brightness (-> Check parameters of the actual device, it might be configurable).

99 = highest level = 100 % brightness (-> Check parameters of the actual device, it might be configurable too).

 

There is no "value 100".

 

Special case: you can *set* the value to:

255 = previous level = same as "turnOn" = what the dimmer remembers, last time it was on.

After setting it to 255, the dimmer reports the actual level (for instance: 75).

 

Does this help?

[systemfel 21]

22 hours ago, sonnyboy said:

i have changed  all that.. i know you are fro sweden so i ask in swedisch know..  Hur gör jag att den söker på ett större värde än 1 för är den nu lika med 1 så blir det ju rätt men behöver nog så den kollar  på ett värde som är större   = > typ kolla jag med din kod hade den tex 28 på dimmern  värdet då

It should be turnOff not turnoff. 

 

Works for me 

[DEBUG] 22:07:21: Test: 99

Please login or register to see this code.

 

 

[sonnyboy 11]

Hej 

Kan detta hjälpa dig?

Funkar för mig

 

Hittade ett par till fel i stavning och mellanslag

Please login or register to see this code.

 

[DEBUG] 20:43:41: turn off the light
[DEBUG] 20:48:50: turn off the light
[DEBUG] 20:48:59: turn off the light

Edited October 10, 2017 by sonnyboy

[petergebruers 1,265]

If english is really too difficult for you, you do not have to answer this... But I'm trying to help. And I am really curious! Why would you want to turn of a dimmer immediately when it is on? All code so far checks device 391 then turns off that very same device. What are you trying to do?

 

What happens if you save this scene and turn on/off the dimmer? What does it print?

 

Please login or register to see this code.

 

 

[BOT 1]

The topic has been moved from "

Please login or register to see this link.

" to "

Please login or register to see this link.

".

 

Temat został przeniesiony z "

Please login or register to see this link.

" do "

Please login or register to see this link.

".