Linked Devices for Heating Panel

[Stealth 10]

I'm having problems trying to set up the Heating Panel and I could do with some help please.

 

My setup-

 

I have a Fibaro relay actuator that is used to turn my heating boiler on ready to accept a signal/call from the room (Heat-It) thermostat when heat is required.

 

If I operate the Fibaro relay manually to turn on the boiler and then set the room thermostat temperature manually the boiler fires up and heats the room okay.

 

When I installed the Heat-It Z-Wave thermostat it shows in the room as three devices as detailed below -

 

Please login or register to see this attachment.

 

I have tried to link the Heat-It thermostat (in the linked devices panel) to the Fibaro boiler relay but I don't see the Hall Thermostat in the Linked Devices list,  I only see the Hall Temp and the Fibaro boiler relay.  I need to be able to set/change the Heat-It thermostat temperature, hence I think I need to link the Hall Thermostat?

 

Can anyone help please?

 

Fibaro HC2 OS is version 4.151 Beta

 

Thanks

Steve

Edited December 29, 2017 by Stealth

[Muehle 2]

You can only link sensors and actors. Hall Temp is the only sensor in your Heat-It-Thermostat.

[Stealth 10]

11 hours ago, Muehle said:

You can only link sensors and actors. Hall Temp is the only sensor in your Heat-It-Thermostat.

 

Yes I know the Hall Temp is only a sensor.  My question was why isn't the thermostat showing up in the list, I would class it as an actuator!  This makes the Heating Panel is completely useless!

[Muehle 2]

What happens if you link the Hall Temp with your Fibaro relay?

I don´t use linked devices. I use a LUA script. The script compares the measured temperature with the desired temperature and if there is a difference, it turns on my boiler.