danfoss temperatur sensor

[Soft 17]

Hi all,

will you be able to use the set point functions in this within Fibaro

I want to use this as a manual temp controller for the mulitreg thermostats 

[Paramjeet 0]

You can use the app to change set points and the length of time you  want  the temp to remain.  You cannot however make any changes from the thermostat side.  I did raise a ticket two yrs ago about this and they said they would look at it.  But it becomes a very expensive thermostat that only does one thing.  For less money you could a number of sensors that have thermostats built in.   Hope that helps. 

[Soft 17]

I don't understand why you would use the app to change the set points?, is this controlling the danfoss devices directly!

 

All I need is a human input on site device,  that will show what the temp is, and  have some buttons to change the temperature:-)