Emergency Lighting not stopping

[MattyO 4]

I am trying to setup a panic button using a fibaro The Button. When I use the alarm panel and enable emergency lighting. Even when I disarm the alame the lighting continues. this can go on for ages. I have even had to restart the HC2 so the lights will stop flashing. Can anyone give me some advice. Thanks Matt . HC2 . v4.170

Edited April 8, 2018 by MattyO

[T.Konopka 8]

A simple scene turning off the lights would do the trick.

[Earplugged 6]

I have the same problem that the emergency light keeps going after disarming, is there any parameter that can control this?

 

If i turn off the light it starts flashing again anyway.

[Harald 0]

Same issue. This is broken.

Oh, and it also power cycles my panel ovens that are connected with Fibaro Wall Plug.

[The Crown 0]

Same problem.. how to fix IT?

 

[Sankotronic 2,370]

On 11/21/2018 at 3:08 PM, Harald said:

Same issue. This is broken.

Oh, and it also power cycles my panel ovens that are connected with Fibaro Wall Plug.

 

Hi @Harald ,

 

Go to your power plug parameter settings and disable response to alarm frames. Plug version 25.25 is parameter 35, plug version 32 parameters 30 and 31.

 

[Rozso2 1]

I have the same problem. Is there any solution?