[SOLVED]24v solenoid valves

[Damir Popovic 0]

Is it possible to use Fibaro Relay Switch to start/stop 24v solenoid valve used in irrigation system? Any manual on this?

[marecki_0luk1 23]

Of course it is. I am using old double switches which has "IN" terminal. Attach to "IN" 24V and thats all. Look for FGS-212 or FGS-222. 

[Damir Popovic 0]

thanks for your response.

To be straight I'm not techy guy so I do not understand your advice.

I would appreciate if you could tell me which wires should be connected to what. I need to tell this to my electrician.

 

[marecki_0luk1 23]

Godzinę temu, Damir Popovic napisał:

aight I'm not techy guy so I do not understand your advice.

 

I found it on internet in 10 seconds

Please login or register to see this image.

[Damir Popovic 0]

thnks.

In this wiring diagram there is 12V  adapter and I should put 24V adapter because solenoid valves are on 24V?

[marecki_0luk1 23]

Yes you should put 24V, but please dont do it on your own.

[Damir Popovic 0]

of course.

thanks on your support.

[TMF 1]

Hey,

 

Can you please tell me if I can see the status of the valve using this module? I want to know if the valves are open or not...

Anyway, I cannot find this module on sale -> FGS-221...

 

Thanks in advance.

 

TMF

Edited May 10, 2019 by TMF

[Jamie mccrostie 82]

@TMFI Don't think  the FGS221 is available now.

Replaced by the  FGS 222 but this has a major difference. 

Please login or register to see this link.

This is now a mains voltage  fed device  with clean contacts to switch your low voltage.

It will still do the job but needs to be wired quite differently.

It would have the mains and low voltage going into the same module so getting a electrician would be recommended. 

Edited May 11, 2019 by Jamie mccrostie

[LeeSteventon 6]

I posted a solution to this also

Please login or register to see this link.

, since I am controlling 24VAC solenoid valves