Another way to connect fibaro dimmer 2?

[SOW 0]

Is this an on way to connect fibaro dimmer 2.?

Please login or register to see this attachment.

[cag014 632]

I think it well described in user manual.

Please login or register to see this link.

please pay attention that figure 1 shows two wire connection, means without neutral wire!

Might be that what you're looking for...

Edited June 17, 2018 by cag014

[SOW 0]

Yes i know it is well described in user manual

 

But I'm asking if this is an ok way to wire the fibaro dimmer 2.

 

If I use it this way I can easily replace all dimmer pucks on all my downlights, and existing lighting in my house.

I dont see the purpouse of "sx", why use it at all? It seems to be working (i have tried one DIMMER2 like picture abowe) but need to know if sx have some sort of safety function.

[cag014 632]

You're right it works with direct connection as well, but as far as I know Sx provides same voltage, but with very low current.  (Back few months I have tested that by connecting resistor and measure the current).

To my opinion in case something wrong with the device and it connected directly to the power line, it may cause potential fire and power failure.

Edited June 17, 2018 by cag014

[jakub.jezek 353]

@SOW, it is correct connection and as @cag014 said it works. But i would suggest to connect button to Sx instead of L. It is safer and no one can tell you a *beep*, since you connected it according to manual.

[T.Konopka 8]

You duplicated that post in a wrong category. Please, be careful next time.