Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


  • 0

Automatically Screw & Unscrews after few min?


fingusio

Question

New factory heat controller Fibaro i try connect to my heater but no success - probably must other adapter? but I do not want to ask about it

 

I charged battery.

I add to HC2, after that I remove heat controller from HC2, make reset (set color yellow and confirm) but he still automatically Screw & Unscrews after few min - is it normall?

should I put him in a standby mode?

Edited by fingusio
Link to comment
Share on other sites

5 answers to this question

Recommended Posts

  • 0

It'll work... It's got something to do with the timing of the button clicks.

 

16 minutes ago, fingusio said:

Heat Controller is not installed i have it in hand

 

It tries to detect the pressure of the valve, and because there is none, it will try again every 10 minutes when in "normal" mode. If you ender stand-by mode it stops. It should also stop if you mount it - unless you have a problem with adapter or valve (as you stated in your first post).

 

 

Link to comment
Share on other sites

  • 0
  • Inquirer
  • I set Standby Mode but after that also screw&unscrew after ~10min

     

    Is it normal?

    Edited by fingusio
    Link to comment
    Share on other sites

    • 0
    13 hours ago, fingusio said:

    I set Standby Mode but after that also screw&unscrew after ~10min

     

    Longs shot... It did not enter "standby". You enter the "menu", then when the LED is cyan, you "click" the internal button. The ring should blink and the motor spins for a few seconds to open the valve. You can then remove the valve. If instead the LED ring fades slowly (does not blink), the FGT did not enter standby and you have to try again.

    • Like 1
    Link to comment
    Share on other sites

    • 0
  • Inquirer
  • Heat Controller is not installed i have it in hand.....ok will try

    Link to comment
    Share on other sites

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.

    Guest
    Answer this question...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

    ×
    ×
    • Create New...