Any way to control Thermostat / Setpoint device?

[ryvaenge 5]

Hi, is there any way to control a Thermostat / Setpoint device? 

Have 2 devices:

Heatit Z-trm2 - floor heating bathroom
Remotec zxt-120 - Heat pump / AC

Edited September 1, 2018 by ryvaenge

[ryvaenge 5]

Made it  

IFTTT & WEBHOOKS & #numberfield

 

Edited September 2, 2018 by ryvaenge

[ryvaenge 5]

Well not 100%

If ZXT-120 setpoint and mode device would have been combined to one device it would have been alot easier.
 

Anyone with experience that can answer this question?

setThermostatSetpoint   (Supported modes is 1: heating 2: cooling 8: dry) 

{"args":[2,16]} 

Where "2" is mode (cooling) and "16" is temperature, is there anyway to avoid filling in the mode like: {"args":[,16]} ?

 What I really want is the mode 3: "Auto" from the setMode device.

Edited September 2, 2018 by ryvaenge

[marius de jong 12]

i control my heat it underfloor heating via lua :fibaro:call(70, "setTargetLevel", currentTemp) to set a set point to the thermostat.
currentTemp is a value i get from the heating panel.

you can replace it with a temperature like this : fibaro:call(70, "setTargetLevel", "22")