Double switch used in association - O1 and O2 cannot be separated. Why?

[Mosskit 4]

Hello

 

I wanted to use in association feature my relay switch 2 (double output: O1 and O2 ver 3.3). Unfortunatelly I am not able to split O1 and O2. Both of them and even scene module gets automatically selected. Is this some kind of misconfiguration of my modules or next great inconsistency in logic of Fibaro developers?
 

Please login or register to see this image.

/monthly_2018_12/Untitled.png.0addd1307e8c67b4e84cc881f5ec805c.png" />
 

Edited December 10, 2018 by AnonymousJohn

[jakub.jezek 353]

Hi @mosskit,

 

Old Z-Wave 300 series devices has Lifeline in last group. So do not touch Group 3, There must be set controller only (if you want status in controller). You probably used manual to FGWPE-102-ZW5 instead of ZW3. Please, check this manual

Please login or register to see this link.

Please login or register to see this spoiler.

 

So that meas On/Off button is in group 1 and Power is in group 2.

 

Z-Wave 500 series devices has Lifeline as 1st group and then goes other functions.

 

It is not issue, that should be reported to Fibaro. It is feature.

Edited December 10, 2018 by jakub.jezek
adding more precise info

[jakub.jezek 353]

Hi @mosskit,

 

Use M column for multichannel control if you do not want to control whole device. Column description is below.

 

Columns:

• Single Channel (S) = Control device as whole
• Multi channel (M) - Control part of device

In this one it is missunderstanding. It is basic Z-Wave thing. See

Please login or register to see this link.

 

Description of associations:

Please login or register to see this link.

[Mosskit 4]

Hi 

Thanks for quick response. 

I tried that one already and it works but not in all scenarios. Let me give you an example. I tried to build simple association between Fibaro Wall plug and Double Switch 2 so that when power goes below preconfigured value (Parameter 50 and 51 of Wall plug) it switches off one circuit on my Double Switch 2. Sounds simple, huh? Now, according to Fibaro Manual I have to use association group no 3 (for power dependent association).

Please login or register to see this image.

/monthly_2018_12/image.png.315135aefc796b6edeb56772f5f5403c.png" />

 

but on that group I am not able to select the "multi-level" column at all. Indeed, I was able to select it on group no 2, but this is not how I want device to be used, by clicking little B-Button on the cover of Wall Plug. 

 

 

 

 

Any ideas?

Edited December 10, 2018 by AnonymousJohn

[Mosskit 4]

@jakub.jezek I compared this behaviour on wallplug in another customer but it was ver 102 (newer one) and here it works as you said! Shall I report this to Fibaro team?

[Mosskit 4]

Solved! Thanks a lot @jakub.jezek. Tried group no 2 and it works now so there is a change between relases and I used newer manual for old device. 

[jakub.jezek 353]

I'm glad it works.