Double Switch 2 with momentary switch, S1 and S2 operation

[Jim66 0]

 I have some double switch 2’s connected with momentary switches, when I press the switch relevant switch S1 or S2 and hold the switch in for any more length of time than just a quick tap the light connected to the device will switch off as soon as I release the switch.
I have parameter 20 set to momentary switch.

I have a smartthings hub and can control modules OK with app. Issue is only when using the local switches.

Anyone know if I can adjust any parameters to change this behaviour?

[PiotrP 0]

Hi Jim66,

I've got the same issue at my place. Have you found the solution yet?

 

Piotr

[BradO 0]

This is a me-too post. I have this exact same issue and can't see a parameter to fix this. I really feel like this is a fault in the device's firmware. I don't know what firmware version my switch is and I'm not sure how to tell.

 

Is there anyone from Fibaro who can comment on this?

[Greenhippo 3]

By pressing and holding the momentary switch, you are making a 'long press'.  This is a different event from a normal press, so the light may respond differently.  In my house I have two configurations:

 

1) With a direct connection from the FGS-223 to the light, a short press turns the light on and a long press turns the light on (when pressed) and has no effect (when released).  Parameter 20 is set to 0.

 

2) With the FGS-223 connected to the light via a relay switch, a short press turns the light on and a long press turns the light on (when pressed) and off (when released).  Parameter 20 is set to 2.

 

I believe this is correct behaviour.