TKB Thermostat paramaters don't show up in the iOS mobile app

[Dunkigrease 0]

I have a number of TKB thermostats in my Fibaro system (HC2 version 4.53 with HCL version 4.53 secondary).  They are all configured OK and I have set the scheduler up to switch them on and off OK without a problem. 

 

The parameters for manual on / off, temperature set, and measured temperature all show fine on the browser views of my controllers, but do not show on the Fibaro mobile app.  I am assuming this is because they are not Fibaro devices and have no template, but it should still be possible to show them despite this.

 

Am I missing something in the et up?

[Dunkigrease 0]

More information.

 

Each Room thermostat  has three parameters showing in the HC2 WEBUI

 

Room Temperature

Room Heat On/Off manual command.

Room heater in heating mode or not.

 

the Temperature element is configured as  Device Kind: Temperature and this shows up in the iphone App but the other two are configured as Device Kind: com.fibaro.operatingMode and com.fibaro.setPoint respectively.    This would seem to suggest that these latter two parameters are expecting values from a Fibaro  Heater Controller perhaps.

 

Can anyone shed any light on how to display these two parameters in the iPhone app?

 

Thanks

[Dunkigrease 0]

This problem only exists  in the new Home Center iPhone App.  It does not occur in the older IPhone App.

[knuth 29]

I have a similar issue with my HeatIt Z-TRM2 thermostats, see my response to

Please login or register to see this link.

.

As @Dunkigrease , I can confirm that the thermostat displays completely and without issues in the old app.