garage door opener

[djh_wolf 0]

Hi, hope you can assist = )

 

I use a simple doorbell as a momentary button to make a contact between two points on my hormann garage door opener. Push a button, door begins to open. push again, door stops. push again, door closes. etc.

 

can i use this product to mimic the same button press so i can open the door using smartthings ? I already have the device installed, where I can see and control s1 and s2 on/off.

 

 

thanks!

[robmac 173]

You need a dry (no volt) contact. The Smart Implant might be able to do what you need but it depends on the voltage and current of that input. Any specs? Model?

[PiotrBr 3]

BTW - same can be done by old relay module (it has dry contact and can be supply from 24V)

 

Piotr