My question is what is the minimum I need to do to the target HC2 that is brand new. I know I need to get it up to the same firmware level and attached to the same Fibaro ID of the donor HC2 but any guidance on how to do that? Do I just connect the new HC2 and go through setup as if it was a new configuration?
Any guidance or advice would be much appreciated as I can see the warnings about not attempting twice etc and would rather get it right.
Question
bdlhome 0
Link to post
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.