Walli Roller Shutter calibration does not stop (blinking white)

[eCoyote 0]

Hi,

 

When I enter calibration mode, leds blinking white, the roller shutter opens fully... but then nothing happens. It stays open, and the LEDs keep blinking white. I've left it for several minutes, no change. It's as if the module does not detect that the motor has stopped.

 

If I exit calibration mode, I can get some up/down movement, but only for a few seconds. I guess the fact that calibration did not complete is preventing any operation.

 

Any idea what parameters I may try changing? I've tried adjusting parameter 155 (motor operation detection) without success. Any recommendation?

 

I have a Fibaro Roller Shutter 3 on another window, which works just great. Any parameter I may try reading from that module, to replicate in the Walli? Operating mode is set to "Roller blinds" and Motor Operation Detection is set to "10" for both. Nothing obvious that I see.

 

Thanks!

Edited January 22, 2020 by eCoyote