Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,


as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.


As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!



Smart Home Forum by FIBARO Team

  • 0

Analog sensors update times on RGBW 2




I'm currently using a couple of RGBW controller 2's with parameter 20 set as 0-10v analog inputs (on a VeraPlus).

They are used with ultrasonic sensors and when polled display accurate readings. 

They just don't update very quickly when the levels change.

I have set the following to try to improve this but it has made no difference:

Parameter 63 - 2 byte dec - 1 (should set increment measured at 0.1v or 1%, the default was 0.5v)


Parameter 64 - 2 byte dec - 1800 (should set periodic reports to 30 minutes).


I changed the level measured by the sensor from 95% to 0% at around 5pm yesterday. The change was finally reported back at 03:24 this morning, over ten hours later.


Both my rgbw controllers act like this despite the parameter setting. If I poll them, the level is immediately updated and correct.

Am I missing something, or can anyone give suggestions on getting timely updates from these please?

Many thanks!

Link to comment
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...