Roller Shutter 3 + LIWIN L25

[0skiii 0]

Hallo i have problem with calibration.

 

I'am playing with 155 parameter, when:

5W >=   actuator working only 1s and make full calibration effect is not even second in 156 & 157 

4W<= calibration open a window and stop, never ending, param 150 stays on 2.

 

Please login or register to see this attachment.

[Martin_N 143]

On 11/4/2020 at 6:01 PM, 0skiii said:

Hallo i have problem with calibration.

 

I'am playing with 155 parameter, when:

5W >=   actuator working only 1s and make full calibration effect is not even second in 156 & 157 

4W<= calibration open a window and stop, never ending, param 150 stays on 2.

 

Please login or register to see this attachment.

 

I think the ideal value for running detection is 10% of the shutter motor power.
For starters, you can start with a default of 10W.
Perform a factory reset. Then calibrate with the B-key and let the cycle complete. Start from the open state.
Then assign to HC3. (the original assignment will stop working after the reset).

 

 

Resetting the device to factory defaults: 
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and 
user configuration will be deleted.
1. Switch off the mains voltage (disable the fuse).
2. Remove the device from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the B-button to enter the menu.
5. Wait for the LED indicator to glow yellow.
6. Quickly release and click the B-button again.
7. After few seconds the device will be restarted, which is signalled 
with the red LED indicator colour.