Remotec ZRC-90 (Scene Master) in Home Assistent

[Ludwig 0]

Hello,

 

Running a Fibaro Homecenter 2 for my Z-Wave devices.

 

Most of my Fibaro devices show up in the Home assistent configuration (switches, dimmers, wall plugs..), except my Remotec ZRC-90 panel..

I can configure it in Homecenter... but then I can only connect it with Z-wave devices. But I want to be able to start a Homeassistent scene with the Remotec.

 

What I can do is make Webhooks for the scenes/scrips I want to use in Homeassistent. But then I need a solution to start this web hooks in Homecenter..

 

Is there someone that can help me to solve this?

[10der 832]

1st of I can't see your version of HC.

2nd uf you have HC3 than Homeassistent has some issues with HC3 in intergration part here

and finally as I know HASS can recognize my ZigBee cube 

Please login or register to see this image.

when i rotate it otherwise it added device as sensor without any actions.

OK I have ZRC-90 a'll test this device in HASS. but i am thinking it not supported.

 

[ChristianSogaard 71]

20 minutes ago, 10der said:

1st of I can't see your version of HC.

2nd uf you have HC3 than Homeassistent has some issues with HC3 in intergration part here

and finally as I know HASS can recognize my ZigBee cube 

Please login or register to see this link.

when i rotate it otherwise it added device as sensor without any actions.

OK I have ZRC-90 a'll test this device in HASS. but i am thinking it not supported.

 

Two questions to your setup.

I also is running Home Assistant in parallel with my HC3- yesterday i disconnected to connection because i had about 3 sec delay when pressing a zwave button before a scene/EV4 was triggered. Do you also see that HA is taking all power of HC3?

Second  question - in the fibaro.yaml exambel

What is the idea of      

• light_device_name_123: 
• binary_device_name_123:

Because all devices are sync into HA - so what do I achieve by defining these?

Do you have a RL example where its used?

 

Please login or register to see this code.

 

[10der 832]

1st of - I haven't real HASS only for developents and investigation.

2nd (again) Fibaro component not properly compatiblity with HC3

 

Please login or register to see this code.

 

and last, i have patched sources for example for disabling adding non visible devices + ugly mappied devices.