Closed status of Fibaro Door/Window sensor delayed

[Twannie 33]

Hi

 

I have strange behavior of door windows sensors from Fibaro, with both old and V2 versions

When opening a door and then closing it within about upto 30 seconds or so the "closed" status is received with a 10 seconds delay by the HC2

So the door sensor shows "closed" in the HC2 interface exactly 10 seconds after closing and scenes triggered run accordingly.

Open status is always, always received without delay!!!!

I have a HC2 with 95 physical sensors, zwave traffic is on average each 6.5 seconds (zwave monitor)

Can some one help me with this? I am stuck

[mariokil 11]

HC2 restarted ?

[Twannie 33]

7 minutes ago, mariokil said:

HC2 restarted ?

yes ;}

[akatar 208]

8 hours ago, Twannie said:

Hi

 

I have strange behavior of door windows sensors from Fibaro, with both old and V2 versions

When opening a door and then closing it within about upto 30 seconds or so the "closed" status is received with a 10 seconds delay by the HC2

So the door sensor shows "closed" in the HC2 interface exactly 10 seconds after closing and scenes triggered run accordingly.

Open status is always, always received without delay!!!!

I have a HC2 with 95 physical sensors, zwave traffic is on average each 6.5 seconds (zwave monitor)

Can some one help me with this? I am stuck

Look in the settings, perhaps you setup a delay

 

[Twannie 33]

I checked everything, parameters, scenes running etc

No luck so far

W

11 minutes ago, akatar said:

Look in the settings, perhaps you setup a delay

 

What settings do you mean btw?

[akatar 208]

15 hours ago, Twannie said:

I checked everything, parameters, scenes running etc

No luck so far

W

What settings do you mean btw?

Please login or register to see this link.

 

[Twannie 33]

Yes, parameters are correct. I also have this with the old version of the sensor

[akatar 208]

please, post youre scene

[Twannie 33]

I do see the door closing late in te interface, even without a scene

but attached the scene anyway

Please login or register to see this attachment.

Edited February 11, 2021 by Twannie

[akatar 208]

just to humor me. kan you use something else as a trigger, a wallplug orso

If you say that in the interface door close is also 10 seconds late, it must be a setting or a problem with hcl

you don't have a zsniffer? then you can actually see if the close is being sent directly of with a 10 seconds delay

[Twannie 33]

if the scene is triggered manually it does not hold voor 10 seconds

I have the hardware for sniffer but did not get into it... need some time to understand that

 

[Twannie 33]

A clean database by support did the trick

this has to be done quite often with a large setup in my experience and energy data is lost ?

[akatar 208]

27 minutes ago, Twannie said:

A clean database by support did the trick

this has to be done quite often with a large setup in my experience and energy data is lost ?

thank you for reporting back to us