Dimmer 2 - solid red

[mamra 0]

Hi, I tried to connect a dimmer 2 with 3x6.2w led dimmable philips spots 

Please login or register to see this link.

and I get solid red.

 

For red says :

RED – Calibration procedure failed. Possible reasons: lack of connected load or connected light source exceeds maximum power, which may be controlled by the Dimmer 2

 

 

Is anything out of fibaro specs?

 

Regards,

S

 

 

[tinman 1,070]

connect Bypass2 parallel to these led spots and run calibration (or apply power and wait till the dimmer2 done with calibration) again.

[mamra 0]

On 2/13/2021 at 5:33 PM, tinman said:

connect Bypass2 parallel to these led spots and run calibration (or apply power and wait till the dimmer2 done with calibration) again.

Thanks for your replay, I will try with Bypass 2 and let you know

[mamra 0]

Hi,

 

After installing bypass 2 my lights works only from switch. 

light.fibaro_system_fgd212_dimmer_2_level is not working (using HA).

 

I think that Force auto-calibration failed cause I get value idle for p13 and p14 doesn't work (show value from previous parameter ). 

 

p2 values are between 49 and 51

 

Any suggestions ?