FGS-214: Q doesn't work if S2 pressed

[Peter Keller 0]

Dear Fibaro community

I'm pretty new in this forum and with Fibaro but I'm expercienced with electrica installation and software programming.

I have a FGS-214 installed. S1 and S2 are On/Off switches and on Q is a ventilator. Therefore Parameter 20 and 21 value 1.

Q turns on if S1 active. But it does not turn on if S2 active.

 

What do I need to do S2 is working in a similar way as S1?

[jakub.jezek 370]

Hi @Peter Keller,

 

Outputs on are connected to Inputs if you do not set Local protection. So you need to create a scene where in condition you would have Input 2 and in action Toggle action of Output.

 

Please login or register to see this spoiler.

 

[Peter Keller 0]

Hi Jakup Jezek

Many thanks for your help it works in general.

I'm working with HC 3 light.

Let me explain little bit more the case.

The idea is S1 or S2 starts the ventilator by using FGS-214. In parallel S1 / S2 are also starting independent lights but without using any smart device, just hardwired (S1 starts Lamp1, S2 starts Lamp2).

If S1 or S2 are turned off, the ventilator should run for e.g. 5 min longer. It works for S1 by using parameter 150 = 1-delayed off and param 154 = 300 s

From my understanding I need your example scence above and change toggle to on

Then I need an additional scence if Output is on AND Button 2 = 1x start timer of 5min and afterwards turn off the device.

How can this additional scence be realized as a block scence? Especially the timer of 5min.