Configure switch as heater

Laurent Crivello · February 21, 2022

Hi, I have added a z-wave device (Qubino) as switch for one of my heaters.

How can I configure it in the hc3l portal so that it can be seen in the Heaters section of the Yubii app ?

Thanks.

jakub.jezek · February 22, 2022

If you want to see it as a switch, then in its general setting set it to Climate category.

Laurent Crivello · February 22, 2022

I actually set it as climate already, but as you can see, it's not seen in the heating devices on Yubii:

Please login or register to see this attachment.

jakub.jezek · February 22, 2022

That is probably because only thermostats and Climate panel (week schedules) are shown in Heating.

@m.roszak, maybe this would something for manuals/kb team to write knowledge base article about what could or could not be shown where in YUBII app.

Sjekke · February 22, 2022

Maybe it’s the Yubii app. I’m still using the old app because of the energy panel. I still haven’t found it in Yubii app.

**m.roszak** · February 23, 2022

I will forward the request to update the manuals.

Question