Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


  • 0

Smart Implant, IN2 status disappears in Home Assistant


Simon W

Question

I have a Fibaro Smart Implant, with 2 magnetic open/closed sensors on its two physical inputs, configured as alarm normally closed input on both, One for a garage door, Two for a gate. Output One of two drives a momentary pulse gate opener, Output Two is not used. The device has Protection enabled on both 1 and 2 so inputs are separated from outputs.

I use ZWaveJS2MQTT with Home Assistant. In ZWaveJS2MQTT both sensors show with their status. This image shows the garage door open/closed sensor at 65-113-1-Home-Security-Sensor, the Smart Implant's hardware status, and the gate open/closed sensor at 65-113-2-Home-Security-Sensor:

Please login or register to see this image.

/monthly_2022_06/image.png.f82603d1ede15ceb2bfb7f3754be765a.png" />

When I open and close the gate, ZWaveJS2MQTT correctly shows the gate sensor (65-113-2) go to Intrusion:

image.png.b56352f6498eb173ae7ce6ca39eb987f.png

However in Home Assistant the gate sensor devices regularly shows as "Unavailable":

image.png.a2d901d98fda6b451aea1f42e924da0a.png

If I re-interview the device the "two" sensors (for some reason the device definition shows both a sensor and a binary sensor for the same actual physical sensor input) come back and work OK in Home Assistant, but after anything from a few minutes to a few hours they drop to unavailable again, even while ZWaveJS2MQTT continues to correctly show the status as idle or intrusion. 

Input 1 (garage door) continues to work fine, always showing in both ZWaveJS2MQTT and Home Assistant correctly. 

 

Anyone have any ideas?

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

  • 0
  • Inquirer
  • FWIW... it appears to have been resolved with later versions of ZWave in Home Assistant. Now works OK.

    Link to comment
    Share on other sites

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.

    Guest
    Answer this question...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

    ×
    ×
    • Create New...