Fibaro Dimmer 2 - Control tube fan

[misterhb 0]

i would like to control a tube fan with a fibaro dimmer. the power ratings are 23 - 37 watts and with inductive load. is this possible ?

Modell VENTS TT 125

[Tim__ 114]

Unfortunately the Dimmer 2 is for lighting only. If you want to control on / off only, then Fibaro Smart Module may work, though technically inductive loads are not supported, and you may need a slave relay.  Otherwise find a fan with 0-10v speed control and you can use a channel of a Fibaro RGBW to set the speed.

[misterhb 0]

ok if i use a master slave configuration how was the final setup looks like in my special szenario ? what kind of devives i need

i have two fans, one pulls the air in, the other off, so both should run syncronously and both

[Tomasz K. 1]

On 6/27/2022 at 9:55 AM, misterhb said:

ok if i use a master slave configuration how was the final setup looks like in my special szenario ? what kind of devives i need

i have two fans, one pulls the air in, the other off, so both should run syncronously and both

Have you successfully connected a tube fan with Dimmer 2?

I have the same challenge and I am curious if it is possible.

 

Kind regards,

Tom

Edited August 2, 2022 by Tomasz K.

[Tomasz K. 1]

Dimmer 2 is working with my lamp & fan in ON/OFF mode.

 

Tom

[Tim__ 114]

Good to know - thanks for posting back Tom!

[misterhb 0]

On 7/28/2022 at 9:54 AM, Tomasz K. said:

Have you successfully connected a tube fan with Dimmer 2?

I have the same challenge and I am curious if it is possible.

 

Kind regards,

Tom

 

Hi Tom

 

I have not implement this setup, because  I want one dimmer for each fan -  what I see in your last Post, you successfully connect an Dimmer 2 to a fan ? whats the technical specification of your fan ?

only on off mode or also speed control

kind regards

hans