HC3 and HC3L on same firmware, cannot add slave

[fdsjkl 1]

 

Both are on firmware 5.141.59

On HC3, I can see the HC3L in "connected gateways" list and shows "5.141.59 - incompatible".

On HC3L,  "connect gateways" option disappeared from the sidebar after updating firmware.

HC3L is fresh out of the box, updated firmware and didn't change anything else.

 

[shouari360 0]

Hello,

I've the same situation with my HC3 and my 2 HC3 lite 

all are on firmware 5.140.17 but still see on the master ⁽

5.140.17 - incompatible

[pnutp0wer 23]

Are both gateways on the same engine? You can check if there is a difference at Settings > Z-Wave.

[shouari360 0]

5 minutes ago, pnutp0wer said:

Are both gateways on the same engine? You can check if there is a difference at Settings > Z-Wave.

The master is on Z-wave 3.0 and both slaves are on Z-wave 2.0

Should they all be on the same engine?

I'll try to by putting the HC3 on Z-wave 2.0 and update the post

Edited August 19, 2023 by shouari360

[pnutp0wer 23]

They need to be on the same engine yes. I don’t know if gateway connection is working on 3.0, but I would still use 2.0 until it is no beta. 

[shouari360 0]

5 minutes ago, pnutp0wer said:

They need to be on the same engine yes. I don’t know if gateway connection is working on 3.0, but I would still use 2.0 until it is no beta. 

Yeah you are right, Thanks.

Just reset to the master to 2.0 and could add all the slaves.

Gateway connection is not working yet for 3.0

Thank you again

[fdsjkl 1]

20 hours ago, pnutp0wer said:

They need to be on the same engine yes. I don’t know if gateway connection is working on 3.0, but I would still use 2.0 until it is no beta. 

This fixed my issue, thanks.