Can Smart Implant close its output contacts using a scene?

[Flix123 1]

I just want to close either the OUTPUT 1 or OUTPUT 2 from a scene, not based on any of the inputs, is it possible? If so, how?

Regards Felix 

[Fabir 70]

@Flix123Block scenes for hcl an hc2 are explained

Please login or register to see this link.

. An example is 

Please login or register to see this link.

 

More examples can be found under fibaro FAQ

Please login or register to see this link.

[Flix123 1]

26 minutes ago, Fabir said:

@Flix123Block scenes for hcl an hc2 are explained

Please login or register to see this link.

. An example is 

Please login or register to see this link.

 

More examples can be found under fibaro FAQ

Please login or register to see this link.

|Thanks Fabir, but those look like  generic descriptions for creating a scene. I have loads of those .  I need to know specifically how to action the outputs of the Smart implant using a scene. In the action list I  see things like "Initital State", "Opposite State", Arsm, Disarm etc.  Nothing clearly saying "close output 1" or so

[Fabir 70]

@Flix123 I don't have a smart implant connected to my hc2 any more.

 

With hc3l it looks like below. This scene runs every 1 minute. It turns on the OUT1 for 10 seconds an than off again.

 

If your SI is included correctly to your hc2, you should  be able to choose from 3 states. Turn On, Turn off and Toggle.

 

 

Please login or register to see this attachment.

 

Edited September 30, 2023 by Fabir

[Flix123 1]

10 hours ago, Fabir said:

@Flix123 I don't have a smart implant connected to my hc2 any more.

 

With hc3l it looks like below. This scene runs every 1 minute. It turns on the OUT1 for 10 seconds an than off again.

 

If your SI is included correctly to your hc2, you should  be able to choose from 3 states. Turn On, Turn off and Toggle.

 

 

Please login or register to see this attachment.

 

Thanks, that GUI looks way better than my HC2. I will do some testing, maybe my options are just named differently. The SI is working well (I'm using it for other purposes)  so the inclusion was ok I think. Vielen dank nochmal und Gruss aus Holland

[Fabir 70]

@Flix123You're welcome. Een prettig weekend