Scenes from S1 Double Switch

[Ilumyne 0]

Hi guys, I create a scene from turn off all of my light when I hold the button. But the relay turn on/off light before, and play the scene after. 
Is there any way to execute just the scene? 

What I need is:

- short press: toggle the internal relay on/off

- long press: execute the scene. 

The parameter 20 is set to 0 (momentary switch)

The parameter 28 is set to 8 (hold and release press)

[JeroenL 8]

Dear all, 

Wanted to post my Scene as a "Crowd solution" but apparently I can not post there. I just bumped into your question, and I would think my solution could help you further. 

 

I made a scene ("Activate / deactivate scene with the wall light switch":  for the following situation

- I have a motion sensor scene that turns on the light in the kitchen

- However, when I turn on the kitchen light with the wall switch, (momentary switch) I want the motion scene to be deactivated. 

- When I turn the kitchen light off with the switch, I want the motion sensor (scene) to become active again. 

 

Parameter 28 of my Dimmer 2 module is set to 1   (should not be set to 8 as mentioned above !! ). 

 

Please login or register to see this code.

 

Please login or register to see this code.

 

Part of the info I needed I found here on the forum: 

 

 

 

Hope it helps to build on for your situation

regards Jeroen

[Ilumyne 0]

On 10/27/2023 at 7:58 AM, JeroenL said:

Dear all, 

Wanted to post my Scene as a "Crowd solution" but apparently I can not post there. I just bumped into your question, and I would think my solution could help you further. 

 

I made a scene ("Activate / deactivate scene with the wall light switch":  for the following situation

- I have a motion sensor scene that turns on the light in the kitchen

- However, when I turn on the kitchen light with the wall switch, (momentary switch) I want the motion scene to be deactivated. 

- When I turn the kitchen light off with the switch, I want the motion sensor (scene) to become active again. 

 

Parameter 28 of my Dimmer 2 module is set to 1   (should not be set to 8 as mentioned above !! ). 

 

Please login or register to see this code.

 

Please login or register to see this code.

 

Part of the info I needed I found here on the forum: 

 

 

 

Hope it helps to build on for your situation

regards Jeroen

Hey Dude! Thanks for answer this question. But I have a double switch, not a dimmer. The support of Fibaro answer to me, they said: everytime the relay send a power and after his execute this scene.