Welcome to Smart Home Forum by FIBARO

Dear Guest,

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

As a member you can:

Start new topics and reply to others
Follow topics and users to get email updates
Get your own profile page and make new friends
Send personal messages
... and learn a lot about our system!

Regards,

Smart Home Forum by FIBARO Team

Guest Message by DevFuse

Alarm state on IN1 and IN2 is cancelled after a while

Asked by Intvelt,
October 22, 2023

https://forum.fibaro.com/topic/68635-alarm-state-on-in1-and-in2-is-cancelled-after-a-while/

Followers 0

Question

Intvelt 2

Posted October 22, 2023

I have a Smart Implant with 2 micro switches wired up to IN1 and IN2, with the implant configured as alarm (Parameters 20 and 21 are 0). The implant correctly reports an alarm when a switch opens, but if it stays open for a longer time (20-30 minutes I think), the state is shown as normal again (no alarm). I use this setup to monitor the state of a house lock, with the switch mounted in the bolt well, and having the state of the switch reset after a while makes this setup useless for its purpose.

Is there any way to keep the alarm state on indefinitely (until the switch closes again)?