HCL3 can't update from 5.142.83 (beta) to 5.150.15

[copderoc 1]

Hi all,

 

I have HCL3 with 5.142.83 (beta), I follow

Please login or register to see this link.

, i download the .zip file, set the controller to recovery, repair with local file, it upload the file and update. But after that it reboot eith 5.142.83 again. Any ideas?

 

Thanks.

[Fabir 70]

@copderoc I did the same with my hc3l. Update to 5.150 was sucessfull.

 

The newer fibaro homecenters have two systems. System A and System B. One is running, the other one is in the backup. When you start an update, always the backup system is updatet.

 

Go back to recovery mode and check which software versions are available in the systems A and B?

 

If 5.150 is there, change to this system. 

Edited November 29, 2023 by Fabir

[copderoc 1]

wow! thanks @Fabir

 

I went back to recovery, I have System A at 5.142.83, and System B at 5.141.59.

I tryed again to update System B with local file update_5142_hc3l.7z as said in

Please login or register to see this link.

. 

 

It loads the file, sistem updating... after that it reboot again in 5.142 beta. I go to recovery again and now I have System A and B at 5.142.83.

 

After that I updated normally to 5.150! thanks

Edited November 30, 2023 by copderoc

[Fabir 70]

@copderoc Contact fibaro support: [email protected]