Several RGB2 Lights stuck in configuration mode after power outage

[Biggie 1]

I powered down my house. 

 

Now after a reboot I have 6 RGBW showing as 'not configured' I don't really want to go round configuring these i.e removing/adding. As even the function to add is very temperamental  

 

Any quick fixs ?

 

I'm starting to regret Fibaro more trouble then its worth 

[Sankotronic 2,206]

Hi @Biggie ,

 

Quickest solution is to make backup before powering down if possible. Then in case there is something wrong after powering up just restore that last backup.

If there is no backup available, then doing soft reconfiguration of 'not configured' RGBW modules might help.

If soft reconfiguration does not help, then full reconfiguration can be done, but that will definitely change RGBW module ID so after full reconfiguration is successful, you will still have to correct RGBW module ID in the scenes and/or QA that use it.

 

Last solution is to remove RGBW module and then include it again to HC3 and then again change its ID in the scenes and/or QA that use it.

NOTE - if regular removal of RGBW module does not work then you will need to force removal and also reset RGBW module before inclusion.

 

[Biggie 1]

Phew many thanks just after writing I realised the soft configuration helped 

 

I defo need to do more back-ups