Info about DS18B20 sensors with FIBARO Smart Implant

[s_pnz 0]

Good Morning,

 

I would like to build a multi-zone temperature reader, using two DS18B20 sensor and one Smart Implant module.

 

I read on instructions that multiple DS18B20 are usable on Smart Implant by connecting them in parallel, but I have a question:

 

- on the gateway will I have 2 different temperaure readings from the 2 sensors or only one temperature value (maybe a "median" value of the readings of the 2 sensors)?

 

Thank you very much

 

Ste

[Fabir 73]

@s_pnz You connect up to 6 DS18B20 Temp Sensors to one Smart implant. Each sensor will show its momentary temperature. No median value. 

I recommend to use:

Powersupply 12 Volt 2 Amp

The cable for each sensor not longer than 3 meters

 

Make sure all sensors are connected correctly before you include the smart implant to the yubi home controller. If you make any changes on the wiring, you have exclude / include the smart implant again. 

 

For each temp sensor you will see a chart like below.

 

Please login or register to see this attachment.

Edited December 30, 2024 by Fabir

[GanzConrad 7]

be aware of this issue:

I stopped ultilize implant with DS18B20, Every power failure resets all temp sensors to zero

Edited December 30, 2024 by GanzConrad

[Tim__ 126]

This might help too

 

[s_pnz 0]

Many thanks to all of you!