Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Search the Community
Showing results for tags 'dim'.
Found 2 results
-
Hello, i'v installed a dimmer2 (FGC-212) with a 2-wire connection to a regular 60W incandescent light bulb with a toggle switch. I can control the dim level using the app BUT if i swipe it to more then approximately 80% , then the light goes off. In the dimmer advance settings, i'v selected the "toggle" option. I have also get this error message in the notification area "Caution! Mains voltage drop detected" In addition, i have some questions that i hope you can answer : 1. Can you set the toggle switch of the dimmer to off / dim max when using the switch? means that i could dim the light only from the app. 2. Can i use the dimmer on a non-dimable LED just for on/off the light (since i have a room that i can not get N wire to there). 3. Is there any way to control TV ( i saw an LG plugin but i'm not sure how to enable it) 4. Can i connect a roller shutter + light to one roller shutter sensor (i guess not, but maybe you will surprise me). Thanks !!
-
Hi, I have a Dimmer 2 that I'm using with 16x 5w Megaman dimmable LED GU10s (141391). It's in a 3-wire configuration. I'm using them with a Vera Edge but I don't think that's important for my issue. My issue is that it doesn't dim down anywhere low enough. At full brightness they report 87 watts, but at 1% dim, they are currently reporting 20.3 watts which is still pretty bright! Also, the dim range is far from linear. There is almost no decrease in light/power dropping from 100% to 50%. It's only when I get below about 40% that there is much noticeable decrease. I've done a couple of re-calibrates but it doesn't seem to help. After doing so Variable 1 (min brightness) is set to 10 and 2 (max) is set to 46. I've tried setting variable one lower but the value doesn't seem to stay. Would the Dimmer Bypass 2 maybe help me out here? Thanks Richard
