Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'powersurge'.
I have one Dimmer 2 in a 2 wire connection. The load is 6 x 12v halogen spots, 35 watt. The load should not be to much as far as I can see, but I get Power Surge error all the time. The transformer is a standard transistor type. I have tested the following without any luck: 1. Adjusted max and min parameter 1 and 2 to minimum 20 and max 70% 2. Forced several autosync #13 3. Then manually forced the dimmer by parameter #30 to Trailing Edge mode, and tested leading edge as well, no changes 4. Even tried to change L and N to the "wrong" position just to verify 5. Fully reset the device Firmware is the latest, I think it's V3.5. Does anyone have any suggestions? Thomas