Welcome to Smart Home Forum by FIBARO
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Smart Home Forum by FIBARO Team
Search the Community
Showing results for tags 'unconfigured'.
Found 3 results
Zipato ZP3102, cannot configure
Roger954 posted a question in Other Devices / Third-party devicesI've added a Zipato ZP3102 as a new device to HC2, 4.560. It shows up in the 'Unconfigured devices' list, no full configuration. I chose 'Reconfigure', woken up the device a zillion times, no success. HC2 does show the message 'ID xxx: Device configuration finished' after a soft configuration, but the configuration status remains 'Not configured'. Notifications show '[Reconfiguration failed]' with a spinning waiting sign. I retried soft- and hard reconfiguration multiple times but no to avail. The device reports its temperature fine but not any motion. In the devices list it shows 'Never breached' but the hardware does detect motion, the light in the detector flashes once when it detects motion. But apparantly no communication between HC2 and the Zipato ZP3102. When I wake up the device by pressing the program switch or activate the 'tamper mode', both motion and temperature device in the fibaro devices-list show 'transfer OK'. Just to revert back to the message 'Never breached'... Any ideas how to get the motion-communication going? Thanks
Aeotec Range extender
Jamie mccrostie posted a question in Other Devices / Third-party devicesAlways when I include the Aeotec range extender it stays unconfigured . Any ideas?
since setting up my Garage controller (aeon Labs model: https://aeotec.com/z-wave-garage-door-controller) it has displayed as being Not Configured. i can manually open and close the door from the interface but when i comes to putting this into a block scene (i only have a HCL) i am unable to choose the device. Ideas?