All LEDs on at power-on: low temp!

[RiccardoCanetta 13]

Hi

Today I found my HC2 stuck at boot with all leds on: both in rescue mode and normal boot would end up with all leds on and no possibility to reach gateway, not even with rescue ip address.

I realised that the temperature in the room (in a house where we don't normally live) was too low, around 5 degrees. I heated the HC2 in front of a wood stove and then it magically started up normally!!

So I now programmed HC2 to keep minimum 10 degrees in its room, as per its technical specs

Hope it helps someone else stuck with all leds on..

Riccardo

[deanrparry 19]

So the problem to all my Fibaro issues is warm it up

Please login or register to see this image.

/emoticons/default_smile.png" alt=":)" srcset="https://forum.fibaro.com/uploads/emoticons/[email protected] 2x" width="20" height="20" /> your a legend! time to seach ebay for a home automation centre hot water bottle!

[djesko 1]

Hi

Today I found my HC2 stuck at boot with all leds on: both in rescue mode and normal boot would end up with all leds on and no possibility to reach gateway, not even with rescue ip address.

I realised that the temperature in the room (in a house where we don't normally live) was too low, around 5 degrees. I heated the HC2 in front of a wood stove and then it magically started up normally!!

So I now programmed HC2 to keep minimum 10 degrees in its room, as per its technical specs

Hope it helps someone else stuck with all leds on..

Riccardo

Did have the same problem and did have normal temp in the room ,  no recovery or response.

 

It all started after going from SW 4.031 to 3.600.

 

Will get a new box from my vendor this week