Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
kintrupf 0
Hi,
![:( :(](https://forum.fibaro.com/uploads/emoticons/default_icon_sad.gif)
I recently got a used Roller Shutter 2 to try it out. Before wiring it to the switch and motor I wanted to check it and include it into my Z-Wave network.
I attached the two power wires to the N and L port of the device, plugged the cable into a socket near my Z-Wave controller and tried to initiate the inclusion process, but to no avail.
Resetting the device as documented in the manual does not seem to work either, the device appears to be completely "dead"
So my question is: should the Roller Shutter 2 work with only the power cables attached or do I need to attach ALL wires before I can include it into my Z-Wave network?
Thanks!
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.