Fibaro as an alarm system

[gusqua 4]

I would like to use Fibaro as an alarm system. I have a house with a garden. in the garden I have motion sensors and Netatmo Prescence cameras that detect if it is a person and send an event. Then my house has 6 accesses where I have an opening sensor in each one and in some motion detectors.
My idea is to make two zones. One that activates the internal zone only (the doors with opening and / or movement sensors) and the outer part, I understand that integrating the presence cameras to avoid false alarms.

To activate or deactivate it, I would like to do it with a scene or a virtual device, where they will also indicate when I set the alarm that all the devices are fine.

If the alarm is activated what I would like is to receive a push message on the smartphones with an option to turn it off or delay the shot and if after minutes you do not receive anything that starts to turn on the lights, LEDs and sirens that I have in Fibaro Alarm panel.

Has anyone seen or seen something like this in the forum?

What do you think? Is it reliable?

 

It is also important that it be simple so that everyone who lives at home can activate and deactivate it.

 

Many Thbaks

[johndeere 9]

On 12/26/2019 at 9:23 AM, sjamaBe said:

 

Same question here, not being a LUA wizard, is there a possibility to activiate/de-activate the alarm panel from a block scene ?

This is what I'm looking for too, but nobody could confirm so far...